3.How to maintain the reactor?

Hello, your editor today is online, and today I will continue to update your little knowledge of maintaining the reactor.

(7) Safety device: It adopts positive arch metal rupture disc and is made of stainless steel. It is manufactured according to the standard GB567-89 "Technical Conditions for Arch Metal Blasting". It has been tested at the factory and cannot be adjusted at will. If it has been ruptured, it needs to be replaced again. The replacement period is determined by the user unit according to the actual situation of the unit. For those who exceed the blasting pressure of the rupture disk but not blasted, it should be replaced. Attention should be paid to the convex side of the bursting disc.

(8) After the reaction is completed, first cool down to lower the temperature, and then discharge the gas in the kettle to the outside through the pipeline to reduce the pressure in the kettle to normal pressure. It is strictly forbidden to disassemble under pressure, and then loosen the main bolts and nuts symmetrically Remove, and then carefully remove the kettle lid (or raise the kettle lid) and place it on the bracket. Special care should be taken to protect the sealing surface during lid removal

(9) Cleaning in the kettle: Use cleaning fluid to clean the residue of the kettle body and the sealing surface after each operation (the cleaning fluid should be used to avoid corrosion of the main material). It should be cleaned frequently and kept clean. Wash the substance or rough surfaced objects.