Meng! 5l kneading machine is small, but the function is powerful!

5l laboratory kneading machine believes that many people will not be unfamiliar, because it is widely used, good effect, easy to operate, etc., fatal many users are welcome, then the laboratory kneading machine is small, but what are its functions?

5l laboratory kneading machine advantages: don\'t look small, the function is quite a lot. It has small volume, small footprint, easy operation, or experimental production, small batch trials, etc. Now many users also use this laboratory kneading machine to do experimental production first, and then mass trials.

So what can the 5l kneading machine do? It is widely used in high viscosity sealant, silicone rubber, silicone rubber, BMC, battery, ink, dye, medicine, resin, plastic, cosmetics and other industries. So, don\'t look at it small, the function is quite a lot!

Pay attention to or how to maintain when operating the 5l kneader? Here are a few points:

1. After the kneading machine is installed, first clean, decontaminate and wipe the anti-rust grease. Check each lubrication point and inject lubricant (fat).

2. Check the tightening of the V-belt before driving, and move the motor to the appropriate position by adjusting the bolt.

3. Check if the fastener is loose, if the steam pipe leaks, and whether the circuit and electrical equipment are safe. The electric heating type kneading machine must have a grounding device.

4. Clean the kneading machine room before the test, and run for 10-15 minutes to confirm that the machine is running normally and then put into production. Usually, the new machine gear (including the reducer) has a large noise at the initial use, and naturally decreases when it is to be engaged for a while.

5. When using steam to warm, the inlet pipe should be equipped with safety valve and pressure gauge, and the steam pressure should not exceed the pressure requirement of the mixing tank of the sign knowledge.

5l kneading machine structure? It mainly consists of six parts: kneading part, base part, hydraulic system, transmission system, vacuum system and electronic control system. The kneading part is composed of a cylinder body, a pulp shaft, a wall plate, a cylinder head, and the like.

In fact, it is only a small size, but the function is not changed at all, but also exquisite and practical, the small partners need to hurry to consult! do not miss it!