Interpretation: Principles and Operating Rules of Silicone Rubber Kneader

The silicone rubber kneading machine is also used as a kneading machine, mainly for different application scopes, and its specifications, parameters and requirements are selected according to user requirements. It is a kind of equipment for mixing, kneading, crushing, dispersing and polymerizing high-viscosity and ultra-high viscosity elastoplastic materials into chemical products. It has full functions, varieties and applications, and is especially suitable for plastics, rubber and silicon. Rubber, dyes, pigments, inks, food bases, pharmaceuticals, architectural coatings, carbon, fiber and other industries.

Silicone rubber kneading machine principle:

Working principle of silicone rubber kneading machine: When working, the motor is driven to the active paddle through the reducer, and the driven paddle is driven by the moving gear. The spiral leaf strip animal material of the stirring paddle is used for axial backlog and radial backlog; Backlog, and low-speed backlog; both for extrusion and separation, so that the material is fully smashed, smashed, blended, and evenly mixed to accelerate the physical and chemical reactor.

Silicone rubber kneading machine operating procedures:

1. After the kneading machine is installed, first clean, decontaminate and wipe the anti-rust grease. Check each lubrication point and inject lubricant (fat).

2. Check the tightening of the V-belt before driving, and move the motor to the appropriate position by adjusting the bolt.

3. Check if the fastener is loose, if the steam pipe leaks, and whether the circuit and electrical equipment are safe. Electric heating type kneading machine must have grounding device

4. Clean the kneading machine room before the test, and run for 10-15 minutes to confirm that the machine is running normally and then put into production. Usually, the new machine gear (including the reducer) has a large noise at the initial use, and naturally decreases when it is to be engaged for a while.

5. When using steam to warm, a safety valve should be installed at the inlet pipe.